<< Click to Display Table of Contents > Set Output |
Figure 277: Set Output |
Set Output: Sets the specified output bit of the IO port to high/low. ▪X: Do not care / Ignore input bit. ▪0: Wait for corresponding bit state 0. ▪1: Wait for corresponding bit state 1. Combine: Allows to set multiple output bits at the same time. Pulse: If selected the output bit gets set to its previous state again, n ms after the bit was set. Use as Default: Set the current configuration as default. Default name of the control is for current shown state: '0036 - 0034' (mask is hexadecimal 0036, output state for this mask is hexadecimal 0034) |
---|
Bit position count starts with "1", but corresponds to bit "0" at the hardware! Find Bit to Pin assignment in Global Settings → IO |